Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Left Aerosol Fan cable is not damaged and is correctly connected to the PrintMech
PCA.
●
Check that there is no obstacle blocking the fan.
●
Replace the Left Aerosol Fan.
SE 44.2:10
Cause: Right Aerosol Fan stopped or spinning at lower speed
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Right Aerosol Fan cable is not damaged and is correctly connected to the
PrintMech PCA.
●
Check that there is no obstacle blocking the fan.
●
Replace the Right Aerosol Fan.
SE 44.4:10
Cause: Right Aerosol Fan Filter blocked
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Right Aerosol Fan cable is not damaged and is correctly connected to the
PrintMech PCA.
●
If the system error persists, replace the Aerosol Filter.
SE 45:03
Cause: Rewinder servo shutdown
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Open the Window and check for any visible obstacles restricting the movement of the Drive Roller.
If there is a wrinkled mass of paper inside the paper path, lift the Pinch Wheels (using the Media
Lever) and clear the obstruction.
●
Replace the Rewinder Motor.
ENWW
Continuable and non-continuable error codes
59
System error codes
To Next Page
Loading...
