ENWW 7-16
Bluetooth printing does not work
Check the wireless settings
From the Toolbox, click the Printer Services tab and then click the
Configure Bluetooth Settings button. Make sure your Bluetooth settings
are correct. Also see Bluetooth printing.
Send the print job again
There may be a loss of data; try sending the print job again.
Check the software
Make sure any necessary software is installed in the host device, for
example, BtPrint-hp for Palm OS PDA users. If you are still having
problems, consult the documentation for the PDA or notebook computer.
For more information on using Bluetooth, see the Bluetooth printing guide at
http://www.hp.com/support/dj450
.
Solving media feed problems
This section provides solutions to common media feed problems.
Media is not picked up from the input tray
Make sure to pull up the input tray extension.
Remove the media, fan it, and reload.
Make sure the media is squarely against the alignment guide and that the
paper guide is snug, but not tight, against the media. For media using the
card slot, make sure the media is aligned squarely against the right edge of
the card slot. Adjust the paper guide on the slot until it fits snugly against
the left edge of the media.
Make sure the media you are using is not wrinkled, bent or curled. Uncurl
paper by bending it in the opposite direction of the curl. Do not leave media
in the input tray overnight. Leaving media in the input tray overnight can
cause it to bend.
Do not load more than 45 sheets of plain paper or a stack paper more than
0.18 in (4.5 mm) thick into the input tray. For other media input capacity,
see Printer Specifications.
To Next Page
Loading...