HP Deskjet 6122 - Accessibility Information

network configuration page
10. Total Packets Received:
Number of
packets received without
error.
11.
Unicast Packets Received:
Number of
packets specifically
addressed to the printer.
12.
Broadcast Packets Received:
Number of
packets addressed to all
devices on the network received.
13. Bad Packets Received:
Number of
packets received with
errors.
14. Total Packets Transmitted:
Number of
packets sent without
error.
15. Unicast Packets Transmitted:
Number of
packets addressed to a
specific device on the network
transmitted.
16. Broadcast Packets
Transmitted: Number of
packets
addressed to all devices on the
network transmitted.
17. Transmission Error Packets:
Number of
packets not sent due to
errors.
port configuration
18. Port Configuration: Type of ethernet port. This setting is determined by the network
to which the printer is connected and is not configurable from the printer.
● 10T FullDplx: Printer can simultaneously transmit and receive data (full duplex)
at 10
Mb/s (megabits per second).
● 10T HalfDplx: Printer can transmit and receive data at 10 Mb/s, but must
transmit or receive separately (half duplex).
● 100TX FullDplx: Printer can simultaneously transmit and receive data (full
duplex) at 100
Mb/s.
● 100TX HalfDplx: Printer can transmit and receive data at 100 Mb/s, but must
transmit or receive separately (half duplex).
file:///C|/enu/ug_ethernet_network_page_fs.html (4 of 4) [12/17/2002 1:00:30 PM]