Load envelopes
a. Raise the input tray
❑
Raise the input tray.
b. Lower the output tray
❑ Lower the output tray and pull out the tray extender.
c. Slide paper-width guide to the left.
❑ Slide paper-width guide to the left.
❑ Remove all paper from the main input tray.
d. Load envelopes.
❑
Insert one or more envelopes into far-right side of the input tray. The side to be printed on should
face up. The flap should be on the left side and facing down.
❑
Slide stack of envelopes down until it stops.
❑ Slide paper-width guide to the right against stack of envelopes until it stops.
Load media 19
Paper basics
To Next Page
Loading...