Contents
x
Table 4–2: Power Supply Cable Configuration.................................................4–19
Table 4–3: SCSI Cable Configuration..............................................................4–20
Table 4–4: FDC Cable Configuration...............................................................4–21
Table 4–5: MAU and Audio Cable Layout.......................................................4–22
Table 5–1: System Troubleshooting...................................................................5–2
Table 5–2: Disk Drive Troubleshooting .............................................................5–8
Table 5–3: Audio Troubleshooting.....................................................................5–8
Table 5–4: Monitor Troubleshooting..................................................................5–9
Table 5–5: Error Beep Codes...........................................................................5–10
Table B–1: Processor Features ..........................................................................B–2
Table B–2: System Specifications.....................................................................B–2
Table B–3: System Dimensions.........................................................................B–2
Table B–4: System Environmental Specifications............................................. B–3
Table B–5: Acoustics: Preliminary Declared Values per ISO 9296 and ISO 7779B–3
Table B–6: Bidirectional Parallel Port Pinouts ..................................................B–4
Table B–7: 9-Pin Serial Port Pinouts.................................................................B–5
Table B–8: OpenVMS Port Mapping ................................................................B–5
Table B–9: Keyboard and Mouse Connector Pinouts.........................................B–6
Table B–10: SCSI Port Pinouts ...........................................................................B–7
Table B–11: System Input Power Requirements..................................................B–8
Table B–12: System Output Power Specifications...............................................B–8
Table B–13: Motherboard Switch Settings ........................................................ B–11
Table B–14: Motherboard Jumper Settings........................................................B–13
Table C–1: I/O Address Map.............................................................................C–1
Table C–2: Default System Interrupt Assignments............................................C–2
Table C–3: DMA Channel Assignments............................................................C–3
Table C–4: SCSI ID Assignments .....................................................................C–4
Table E–1: Starting a Windows NT Workstation Installation ............................ E–3
Table E–2: Setting Up Partitions for a Windows NT Installation....................... E–5
Table E–3: Starting a Digital UNIX Installation................................................ E–6
Table E–4: Starting an OpenVMS Installation................................................... E–7
Table F–1: Hardware Components.....................................................................F–2
Table F–2: ISA Equipment Configuration..........................................................F–3
Table F–3: SCSI Addresses................................................................................F–3
Table F–4: Hardware Configuration...................................................................F–4
Table F–5: Installed Software ............................................................................F–4
Table F–6: Additional Component Information..................................................F–4