HP DL120 - ProLiant - G5 - Optical Drive and LED Cable Options

Hardware options installation 20
SAS hard drive LED cable option
The SAS hard drive LED cable provides LED functionality for SAS hard drives when an optional SAS
controller and an optional SAS controller cable are installed.
To install the component:
1. Power down the server (on page 6).
2. Remove the server from the rack (on page 6).
3. Remove the primary access panel (on page 7).
4. Install the optional SAS controller ("Expansion board option" on page 24).
5. Connect the SAS hard drive LED cable to the system board and to the SAS controller.
6. Install the primary access panel.
7. Install the server into the rack.
12.7-mm optical drive assembly option
To install the component:
1. Power down the server (on page 6).
2. Remove the server from the rack (on page 6).
3. Remove the primary access panel (on page 7).
4. Remove the secondary access panel (on page 7).