Display assembly
Description Spare part number
15.4-inch, WXGA, BrightView, display assembly for use only with computer models equipped with a
camera (includes camera and cable, microphones, and WLAN transceivers and antenna cables)
446481-001
15.4-inch, WXGA, BrightView, display assembly for use only with computer models not equipped
with a camera (includes microphones and WLAN transceivers and antenna cables)
446482-001
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 37).
5.
Remove the memory/WLAN module compartment cover (see
Memory module on page 44).
6.
Disconnect the wireless antenna cables from the WLAN module (see
WLAN module on page 47).
7.
Remove the following components:
a.
Keyboard (see
Keyboard on page 55)
b.
Switch cover (see
Switch cover on page 51)
c.
Speaker assembly (see
Speaker assembly on page 53)
Remove the display assembly:
1.
Close the computer and turn it upside down, with the rear panel toward you.
2.
Remove the Phillips PM2.5×7.0 screws that secure the display assembly to the computer.
3.
Turn the computer display-side up, with the front toward you.
4.
Open the computer to an upright position.
58 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
