● Speaker cable (3)
● Display cable (ZIF) (4)
● USB cable (ZIF) from USB board (5)
● USB cable (ZIF) from system board
(6)
● Touchpad cable (ZIF) (7)
● Keyboard backlight cable (ZIF) (select products only) (8)
● Keyboard cable (reverse ZIF)
(9)
● Fingerprint reader cable (ZIF) (select products only) (10)
● Important: Do not disconnect the RTC battery cable
(11)
● Antenna cables from the WWAN module (select products only) (12)
2
. Remove the port bracket (1), by removing the three Phillips M2.5 × 4.0 screws (2) that secure the
bracket to the system board, and then removing the bracket (3).
3. Remove the two Phillips M2.0 × 2.5 screws
(4) that secure the system board to the computer.
Component replacement procedures 59
To Next Page
Loading...
