Fingerprint reader assembly
Description Spare part number
Fingerprint reader assembly (includes EMI gasket) L13681-001
Fingerprint reader cable L13678-001 (Cable Kit)
Fingerprint reader bracket L13693-001
Fingerprint reader EMI gasket L13695-001 (Misc Parts Kit)
Fingerprint reader insert (for use in models without a ngerprint reader) L13692-001 (Plastics Kit)
Before removing the ngerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 43).
Remove the ngerprint reader assembly:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the ngerprint reader bracket to the computer.
2. Lift the bracket from atop the ngerprint reader assembly (2).
Component replacement procedures 51
To Next Page
Loading...
