12. If it is necessary to remove the ambient light sensor board, disconnect the cable from the board (1), lift
upward to disengage the board from the adhesive on the display enclosure (2), and then remove the
board from the display (3).
The ambient light sensor board is available using spare part number L15511-001.
13. If it is necessary to remove the display panel from the enclosure, use a at, non-marking tool to lift up
the top left corner of the panel (1). Lift the top (2), left and right sides (3), and then remove the panel
from the enclosure (4).
The touch control board, cable, and display panel are available in the Touch Panel Kit using spare part
number L30424-001.
14. If it is necessary to remove the touch board:.
Component replacement procedures 71
To Next Page
Loading...
