Service cover
Description Spare part number
Service cover 704441001
Before removing the service cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 41).
5. Remove the hard drive cover (see
Hard drive cover on page 47).
Remove the service cover:
1. Loosen the 5 captive Phillips screws (1) that secure the cover to the computer.
2. Tilt the door up from the computer slightly (2), and then lift the cover up and off the computer (3).
Reverse the removal procedures to install the service cover.
Component replacement procedures
53
To Next Page
Loading...
