Hard drive cable
The hard drive cable is secured with two Torx screws.
To remove the hard drive cable:
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the top cover (Top cover on page 21).
3. Remove the hard drive (Hard drive on page 29).
4. Disconnect the hard drive cable from the system board (1).
5. Remove the two Torx screws that secure the hard drive cable to the computer (2).
6. Lift the hard drive cable out of the computer (3).
To replace the hard drive cable, reverse the removal procedures.
Hard drive cable 31
To Next Page
Loading...
