HP EliteDisplay E243d - Preparation and Stand-Base Removal; Rear Cover Removal; Cable and Tape Disconnection; USB Board and BKT Removal

1
12. Mechanical Instructions
Step Figure Description
Preparation and
remove the
stand-base
ass'y
Lay the monitor
on a flat, soft
and clean
surface. Push
the button to
remove the
stand-base
assy.
Remove the
screws to
remove the rear
cover
Remove the
screws to
remove the rear
cover
Disconnect the
cable and the
tapes
Disconnect the
cable and the
tapes
Remove the
screws to
remove the USB
board and BKT
Remove the
screws to
remove the
USB board and
BKT