HPE ProLiant Gen10 DL Servers Storage Cabling GuidelinesHPE ProLiant Gen10 DL Servers Storage Cabling Guidelines
When installing cables, observe the following:
All ports are labeled:
System board ports
Controller ports
12G SAS Expander ports
Most data cables have labels near each connector with destination port information.
Some data cables are pre-bent. Do not unbend or manipulate the cables.
Before connecting a cable to a port, lay the cable in place to verify the length of the cable.
When routing cables from the front to the rear of the server, use the cable channels on either side of the chassis.
To Next Page
Loading...
