Running the Program
Switch to “RUN”
Enter the number 3200.
Press “A” key.
You will see the display flash while it thinks, then stop and
display 32169908.78
Congratulations!
Now you can try different radius values, followed by “A” and
see the results.
Navigating the program editor using:!
SST - single step,
BST (h-shifted SST) - back step,
DEL (h-shifted CLX) - delete instruction
If your program didn’t work the first time, you may need to
edit it. Switch the W/PRGM switch to
!
When you press SST, the next line in the program appears. If
it is OK, you go on to the next one. If not, use the DEL
command to delete the line, then you can re-enter a new line
To Next Page
Loading...
