The P-bank can store up to 10 numbers for the “X” series of
data. When you have filled those, swap in the S-bank and fill
in up to 10 numbers for the “Y” series of data.
When you done, swap in the S-bank once more to bring back
the “X” series values to the primary P-bank.
Finally, you may use up to 10 numbers, but you don’t have to.
Enter the total number of items into the “ST I” (H-shifted
STO) register as the last step. The “I” register will be used by
the chart builder to count the numbers in registers 0 thru “I”
register when you create your Chart Card.
Note: you can, of course write a program to generate and
store the values based on a custom function you want to chart.
See the “Create Chart Data Example” program for an
example that generates Y=X^2.
To create the chart, click the “Save Data” button on the
bottom menu. Then click “Save as Chart Card”. A set of
input fields will appear:
Chart Title
Chart Type (Scatter, Line, Bar, Spline)
Show Legend
X Label
Y Label
When you click OK the card will be saved.
To Next Page
Loading...
