HP HPE ProLiant DL325 - Removing and Replacing a DIMM; Removing and Replacing a Heatsink; Removing a Heatsink

Removing and replacing a DIMM
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the access panel.
6.
Remove the DIMM.
To replace the component, reverse the removal procedure.
Removing and replacing a heatsink
Removing a heatsink
Before you perform this procedure, make sure that you have a T-20 Torx screwdriver available.
Procedure
1. Observe the following alerts.
Removal and replacement procedures
85