HP Integrity Superdome SX1000 - Installing an Additional Power Distribution Control Assembly; Adding the Option 6 or Option 7 Pdcas

Chapter 3
Removing and Replacing Components
Installing An Additional Power Distribution Control Assembly
92
Installing An Additional Power Distribution Control Assembly
Adding additional capacity to an existing system requires careful consideration and planning. A Solution
Implementation Plan (SIP) should be developed before visiting the customer site.
Figure 3-7 shows a cabinet with both PDCAs installed. PDCA 0 is the first PDCA. PDCA 1 is the position of
the additional PDCA.
Figure 3-7 PDCA Locations
Adding the Option 6 or Option 7 PDCAs
To add the Option 6 or Option 7 PDCA:
Step 1. Shut down the server.
Step 2. Power off the AC supply to the server.
Step 3. Remove the power plug from the power source.
Step 4. Install the new PDCA into the server.
L Bezel
L Bezel
PDCA0
PDCA1
Rear PDCA Bezel