Chapter 3
Removing and Replacing Components
Installing An Additional Power Distribution Control Assembly
93
1. Run the power cord down through the appropriate opening in the floor tile.
2. Partially insert the PDCA into its slot.
3. Slip the L bracket under the power cord on the rear of the PDCA.
4. While holding the L bracket in place, insert the PDCA completely into the cabinet and secure
the L bracket with one screw.
Figure 3-8 Installing the PDCA
5. Using a T20 Torx driver, attach the four screws that hold the PDCA in place.
Step 5. Plug the power cord into the AC power source.
Step 6. Power on the AC supply to the server.
Step 7. Power on and boot up the server.
To Next Page
Loading...
