Chapter 5
Site Preparation
Power Options
154
Figure 5-7 PDCA Locations
Power Cords
This section discusses the different possibilities for PDCA power cords.
Pre-wired PDCAs Options 6 and 7
All servers are delivered with the appropriate cable and plug. The mating in-line connector is not provided.
IMPORTANT Verify that the source power is correct for the appropriate PDCA wiring.
NOTE When installing the power connector, allow enough room for mating the connector with the
plug.
Check the voltages at the connector prior to connecting the newly installed connector to the PDCA plug. Refer
to Figure 5-9 and Figure 5-10 on page 156 for pin locations.
PDCA 0
PDCA 1
To Next Page
Loading...
