Operating System Boot and Shutdown
Booting the SuSE Linux Enterprise Server Operating System
Appendix A
192
SuSE Linux Enterprise Server Operating System Booting from the EFI Shell
Use this procedure to boot SuSE Linux Enterprise Server 9 from the EFI Shell.
See “ACPI Configuration for SuSE Linux Enterprise Server Must Be “default”” on page 191 for
required configuration details.
Step 1. Access the EFI Shell.
From the system console, select the
EFI Shell entry from the EFI Boot Manager menu to access the
shell.
Step 2. Access the EFI System Partition for the SuSE Linux Enterprise Server boot device.
Use the map EFI Shell command to list the filesystems (fs0, fs1, and so on) that are known and
have been mapped.
To select a filesystem to use, enter its mapped name followed by a colon (:). For example, to operate
with the boot device that is mapped as fs3, enter fs3: at the EFI Shell prompt.
Step 3. Enter ELILO at the EFI Shell command prompt to launch the ELILO.EFI loader.
If needed, you can specify the loader’s full path by entering \efi\SuSE\elilo at the EFI Shell
command prompt.
Step 4. Allow the ELILO.EFI loader to proceed with booting the Red Hat Linux kernel.
By default, the ELILO.EFI loader boots the kernel image and options specified by the default item
in the elilo.conf file.
To interact with the ELILO.EFI loader, interrupt the boot process (for example, type a space) at the
ELILO boot prompt. To exit the loader use the exit command.
To Next Page
Loading...
