Appendix B
Powering On and Off the System
Powering on the System Using the pe Command
211
Powering on the System Using the pe Command
This section describes how to power up the system.Use the following procedures anytime the system needs to
be powered on.
Step 1. From the Command Menu, enter the pe command.
IMPORTANT If the complex has an IOX cabinet, power on this cabinet first.
In a large complex cabinets should be powered on in one of the two following orders:
9, 8, 1, 0 or 8, 9, 0, 1.
Step 2. Enter B and then the cabinet number as shown in Figure 0-1.
Figure 0-1 Power Entity Command
Step 3. The power state is OFF. Enter on to power up the cabinet.
To Next Page
Loading...
