Appendix F
Management Processor Commands
MP Command: TE
271
MP Command: TE
TE - Tell
• Access level—Single Partition User
• Scope—Complex
This command treats all characters following the TE as a message that is broadcast when the
<CR> is
pressed. The message size is limited to 80 characters. Any extra characters are not broadcast. Also, any
message that is written is not entered into the console log.
NOTE All users connected to the MP handler will receive the message irrespective of what Partition
the user sending the message has access to.
Example F-25 TE Command
To Next Page
Loading...
