HP Integrity Superdome SX1000 - JET Help Menu

Appendix G
JUST Exploration Tool
JET Interactive Mode
285
1) jab 0x082b2291
2) jab 0x182b2291
3) jab 0x282b2291
Enter selection: 3
Select the correct device for: jab, Reference designator: U2
1) jab 0x082b2291
2) jab 0x182b2291
3) jab 0x282b2291
Enter selection: 3
JET Interactive Update menu.
Select from the following options.
1) Load new node configuration file.
2) Add a Board to an existing node.
3) Remove a Board from an existing node.
4) Load flex mate file.
5) Add a Link.
6) Remove a Link.
X) Return to previous menu.
Enter selection: x
JET Interactive MAIN MENU!
Select from the following options.
1) Run JET.
2) Display current configuration data.
3) Update configuration.
X) Exit
Enter selection: x
JET Help Menu
To obtain help on available JET run parameters, enter the -h argument in the run line as shown in
Figure G-15.
Figure G-15 JET Help Menu
% jet -h
usage: jet [-d <debug level>] [-f <complex> <node>] [-h] [-i] [-v]
Where:
-d <debug level> = set debug level, valid values are 0 - 4.
-f <complex name> <node number> = force a disconnect.
-h = print this help page.
-i = interactive mode.
-o = Use old complex.cfg file format.
-r = Perform Jtag resets on all paths prior to scanning.
-s <complex name> = interrogate only the specified complex.
-v = print JET version information.