Chapter 3
Removing and Replacing Components
Removing and Replacing the Front Electromagnetic Interference (EMI) Cover
85
Removing and Replacing the Front Electromagnetic Interference
(EMI) Cover
There is an EMI (Electromagnetic Interference) cover on the front of the cabinet. This cover is secured with
one captive screw in the lower center of the cover.
Removing the Front EMI Cover
Step 1. Open the front cabinet door.
Step 2. Loosen the single slotted T-25 captive screw in the lower center of the EMI cover.
Step 3. Using the handle on the EMI cover, tilt the cover away from the chassis at the captive screw edge.
Step 4. Remove the cover from the chassis.
Replacing the Front EMI Cover
Step 1. Place the EMI cover onto the chassis, leaving the cover tilted outward from the chassis at the
captive side.
Step 2. Rotate the cover into position flush with the chassis frame.
Step 3. Tighten the single captive screw in the lower center of the EMI cover.
Step 4. Close the front cabinet door.
To Next Page
Loading...
