HP iPAQ hx2000 Series - Charging with the HP Ipaq Cradle and USB Cable

0DQDJLQJWKH%DWWHU\
8VHU·V*XLGH ²
NOTE: The amber charge light on the front of the Pocket PC
blinks while the battery is recharging and turns solid amber
(nonblinking) when the battery is fully charged.
Charging with the HP iPAQ Cradle and USB
Cable
An alternative method of charging the Pocket PC is to charge the
unit by using a USB cable. However, because this charging
method drains the host battery (i.e., laptop), you must enable
USB charging on the Pocket PC before you can charge the unit.
To charge your Pocket PC using the HP iPAQ Cradle and USB
Cable:
1. Turn on USB charging by tapping Start > Settings > System
tab > Power on the Pocket PC.
2. Select the USB Charging tab, and then check Use USB
Charging.
3. Tap OK once USB Charging has been enabled.