HP iPAQ hx2000 Series - Battery Saving Tips

8VHU·V*XLGH ²
0DQDJLQJWKH%DWWHU\
To use a shortcut to view your battery charge level, tap the
battery icon located in the Pocket Panel Lite on the Today screen
plug in.
Battery Saving Tip: Tap Start > Settings > System tab > Power >
Advanced tab, and then tap the Turn off device if not used for
checkbox and set it to turn your iPAQ Pocket PC off after a short
time of not being used.
CAUTION: It is recommended that you do not allow the battery
installed in your iPAQ Pocket PC to discharge completely. Doing so
does not harm your Pocket PC or battery; however, you will lose all
data not stored in File Store (ROM). Discharging the battery
completely is similar to performing a hard reset. Refer to Chapter 1,
“Performing a Hard Reset” for more information.
Battery Saving Tips
Here are some battery saving tips to help save energy in your
Pocket PC battery.
■ Leave your Pocket PC connected to AC power at all times
when you’re not using it. For more information, refer to
“Charging with the AC Adapter” earlier in this chapter.
■ Set your Pocket PC to turn off after a short time if not being
used. Tap Start > Settings > System tab > Power >
Advanced tab. Next, check the “Turn off device if not used
for” box, and then select a time duration.
■ Set the backlight to go off quickly (10 or 30 seconds) after
you stop using your Pocket PC, or implement Power Save
mode to turn off the backlight completely. For more
information, refer to “Changing the Backlight Settings” later
in this chapter.
■ Turn off all wireless activities when not in use. Refer to
Chapter 8, in section “Powering Wi-Fi On or Off” and
Chapter 9, in section “Turning On/Off Bluetooth.”