HP Jet Fusion 4200 - Page 23

Branch circuit breaker specications
4 poles, 32/40 A
Power cable specications
Conguration 3 lines + N + PE
Minimum cross-sectional area 6 mm² or 10 AWG
Terminals Ferrule terminals, except the PE terminal, which uses the M8 ring type
External diameter range 18.0–25.0 mm
Conguration 2: 200–240 V line-to-line three-phase conguration
Printer specications
Number of power wires) 3 lines + PE
Input voltage (line to line) 200–240V (±10%)
Input frequency 50/60 Hz
Power consumption (typical) 9–11 kW
Maximum load current (per phase) 48 A (up to 60 A repetitive peak current)
Branch circuit breaker specications
3 poles, 50/60 A
Power cable specications
Conguration 3 lines + PE
Minimum cross-sectional area 10 mm² or 6 AWG
Terminals Ferrule terminals, except the PE terminal, which uses the M8 ring type
External diameter range 18.0–25.0 mm
Power cables
No power cable is provided with the printer. The cables that you use must meet the minimum specications for
the chosen conguration explained for each conguration, and must follow local laws. The example below is for
conguration 2.
ENWW Printer electrical conguration 19