7. Insert the new internal glass into the two rear brackets, and pull the metallic clip to insert the other
side.
8. Add the frame with the bottom glass, securing it with four screws.
Reassemble the fusing-lamp module
The following steps provide the complete procedure for this topic.
■
See Reassemble the fusing-lamp module on page 132.
Finish the replacement
The following steps provide the complete procedure for this topic.
1. Clean the fusing-lamp glasses. See Clean the fusing-lamp glasses on page 190.
2. Close the top cover.
3. Ensure that all windows, covers, and doors are closed and remain in their original positions.
4. Turn on the printer.
Replace a heating lamp
The following sections provide details for this topic.
At the printer’s front panel, tap the Maintenance icon , then Heating lamps to see the status of
each lamp:
● Missing: The lamp is missing.
● Replace: The lamp has been identified as faulty. It should be replaced by a functional lamp.
● Wrong: The lamp type is not suitable for this printer.
● Not in warranty: The lamp is no longer covered by warranty.
Prepare for replacement
The following steps provide the complete procedure for this topic.
1. Ensure that you have the heating lamps kit, which is included in the printer initial maintenance kit,
but can also be purchased separately.
2. Ensure that the printer is not printing.
3. If a job has just been printed, wait about 20 minutes for the printer to cool down.
4. You are recommended to wear goggles and cotton gloves.
5. If present, remove the build unit.
IMPORTANT: The heating lamps located at zones with 2 lamps (A and B), MUST be replaced
simult
aneously. This means that if, for example, lamp 1A is fused and has to be replaced, lamp 1B
has to be replaced at the same time as well, before resetting the counter.
Reassemble the fusing-lamp module 263
To Next Page
Loading...