2. Connect an explosion-protected vacuum cleaner, and turn it on.
NOTE: If your vacuum hose is different in diameter from the processing station’s connector, there
ar
e three files for adaptors (50, 60, and 65 mm) that you can find in
http://www.hp.com/go/jetfusion3Dprocessingstation/support. To use them, first print them out, then
r
emove two screws as indicated below, introduce the printed adaptor, and secure it with the
removed screws.
3. When finished, turn off the vacuum cleaner and unplug the hose.
Clean the sieve lid
The following sections provide details for this topic.
Remove the dust on the sieve lid and the floor of the machine. If there is a significant accumulation of
po
wder in this area, look for powder leakages in seals on the sieve lid, bellows, hoses, and clamps.
Clean the sieve lid 279
To Next Page
Loading...