9. Take the purge tool from the drawer and place it on the side of the working area.
10. Connect the material loading nozzle to the reusable material collector with the purge tool.
CAUTION: Ensure that the hoses are connected properly. The loading nozzle should be connected
t
o the top and the material collector to the side. If the loading nozzle is correctly connected, the
hose should slope gradually downwards; it should not have an āSā shape.
CAUTION: It is important to keep the purge tool in the indicated position during the whole process.
In case o
f system error, do not disconnect the hoses; restart the processing station and restart the
process, or start an unpacking process to ensure that the material left in the hoses is properly
cleaned. If it is not possible to do either of these things, remove the tool from its position, keeping it
horizontal to avoid possible material spillages.
Clean the processing station 285
To Next Page
Loading...