12. Define the height by scrolling up and down the right bar. You can change the mix ratio if required.
The loading time depends on the mix ratio used and the quantity to load; here are some
appr
oximate examples:
Table 7-2 Loading time
Estimated loading time (min)
Material Mix ratio Full print chamber Half print chamber
HP 3D HR PA12 80% R – 20% F 45 25
HP 3D HR PA11 70% R – 30% F 50 30
TPU Ultrasint 80% R – 20% F 140 75
PA12 GB 70% R – 20% F 45 25
HP 3D HR PP 80% R – 20% F 70 40
NOTE: The percentage full assumes a 20% packing density.
13. Tap Load to continue.
14. Tap Start.
NOTE: To fill the build unit completely with a mix ratio of 80% reusable, 20% fresh, you may need to
do it in t
wo steps if the external tank is not automatic or if it does not contain enough reusable
material.
15. The supply container of the unit is filled. Wait for front panel to report that it has been successfully
loaded.
Loading procedure 51
To Next Page
Loading...