EN Using the Embedded Web Server 177
IPX/SPX
The IPX/SPX tab allows you to configure IPX/SPX (Internet
Packet Exchange/Sequenced Packet Exchange) parameters on the
HP Jetdirect print server for operation on a Novell NetWare or
IPX/SPX-compatible network (such as a Microsoft network). See
Table B.3
for a description of items on this page.
CAUTION If you are using direct-mode printing over IPX/SPX
on a Microsoft network, do not disable IPX/SPX.
Idle Timeout Specifies the number of seconds that an idle connection is
allowed to remain open. Up to 3600 seconds can be set. 270 is
the default value. If set to 0, the timeout is disabled and TCP/IP
connections will remain open until closed by the device at the
other end of the network (for example, a workstation).
TTL/SLP Specifies the IP multicast Time To Live (TTL) discovery setting
for Service Location Protocol (SLP) packets. The default value
is 4 hops (the number of routers from the local network). The
range is 1-15. If set to -1, multicast capability is disabled.
System Contact Identifies a person who is assigned to administer or service this
device. This field may include a phone number or similar
information.
When configured, this parameter will be displayed on the
HP Jetdirect Home page.
System Location Specifies the physical location of the device or related
information. Only printable ASCII characters are allowed, up
to 64 characters.
When configured, this parameter will be displayed on the
HP Jetdirect Home page.
Banner Page Specifies whether to enable or disable printing of an LPD banner
page for print jobs. For HP Jetdirect external print servers that
provide multiple ports, you can configure each port. For internal
print servers, only a single port is available (Port 1).
Table B.2 TCP/IP Settings (3 of 3)
Item Description
To Next Page
Loading...
