EN Using the Embedded Web Server 179
Table B.3 IPX/SPX Settings (1 of 2)
Item Description
IPX/SPX Enable Enables or disables the IPX/SPX protocols on the HP Jetdirect
print server. If the checkbox is empty, IPX/SPX is disabled.
IPX/SPX Frame
Type
Specify the Novell NetWare frame type to be used by the
HP Jetdirect print server on your network. After a frame type has
been configured, all others will be counted and discarded.
● AUTO (default) senses all frame types and configures the first
one detected.
● EN_8023 limits the frame type to IPX over IEEE 802.3 frames.
● EN_II limits the frame type to IPX over Ethernet frames.
● EN_8022 limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames.
● EN_SNAP limits the frame type to IPX over SNAP with
IEEE 802.3 frames.
● TR_8022 limits the frame type to IPX over IEEE 802.2 LLC
with IEEE 802.5 frames.
● TR_SNAP limits the frame type to IPX over SNAP with
IEEE 802.5 frames.
SAP Interval Specifies the time interval (in seconds) that the HP Jetdirect
print server waits to send Service Advertising Protocol (SAP)
messages, which are broadcast to advertise its service
capabilities on a Novell NetWare network. To disable SAP
messages, use the value “0”.
Print Server Name Specify a NetWare printer name for the HP Jetdirect print server
(alphanumeric characters only). The default name is NPIxxxxxx,
where xxxxxx are the last six digits of the HP Jetdirect print
server's LAN hardware (MAC) address.
NDS Tree Name Specify the name of the NDS tree for this device. The NDS
(Novell Directory Services) tree name refers to the name of the
organizational tree used by your network. To disable NDS
support, leave this field blank.
To Next Page
Loading...
