5. Grasp the transfer unit with two hands. Simultaneously pull the release latches on either
side of the transfer unit and slide the unit out of the printer.
6. Remove the new transfer unit from the bag.
7. Hold the transfer unit on either side. Guide the feet into the cups and slide the transfer
unit into the printer.
8. Close the transfer unit and front cover. Close the top cover and turn the printer on. After
a short while, the control panel should display NEW TRANSFER KIT.
9. Press
to highlight YES.
10. Press
to select YES.
11. Press
to reset the transfer unit count.
12. Wait for the printer to calibrate.
Replacing the transfer unit when it is not at end of life
If you replace the transfer unit when it is not at the end of life (for example, if it is defective)
you will need to calibrate the printer and reset the transfer unit count through the control
panel.
Use the following steps to calibrate the printer:
1. Press
(HP Color LaserJet 5500 models) or M
ENU
(HP Color LaserJet 5550 models) to
open the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight PRINT QUALITY.
112 Chapter 4 Printer Maintenance ENWW
To Next Page
Loading...