4. Pull the cover to the right to release the hinge pin on the left side.
Figure 6-4.
Removing and replacing the top cover
Rear top cover
Use the following steps to remove the rear top cover.
To remove the rear top cover
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the two screws shown in callout 1.
4. Insert a flat-blade screwdriver between the top and side covers on the left side of the
printer. Lift slightly to disengage the tab (shown in callout 2) on the left side of the printer.
ENWW Covers and external components 191
To Next Page
Loading...