To remove the fuser drive unit
1. Remove the fuser. See Replacing the fuser.
2. Remove the rear cover. See
Rear cover.
3. Remove the top cover. See
Top cover.
4. Remove the rear top cover. See
Rear top cover.
5. Remove the left cover. See
Left cover.
6. Remove the DC controller shield. See
DC controller shield.
7. Remove the two screws shown in callout 1.
8. Remove the damper plate shown in callout 2, and remove the damper shown in callout 3.
Figure 6-75.
Removing and replacing the fuser drive unit (1 of 4)
9. Disconnect the four connectors (J1110, J1119, J1128, J1101) shown in callout 4.
10. Disconnect the intermediate connector shown in callout 5.
ENWW Internal components (top) 241
To Next Page
Loading...