Q1342-90910 Internal assemblies 47
Face-up roller
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
z Fuser assembly. See “Fuser assembly” on page 42.
2 Turn the fuser assembly over and remove the gear (callout 1)
from the face-up roller
3 Release the tab (callout 2) on the face-up roller bushing and
rotate the bushing forward until the pin releases. Remove the
bushing.
4 Slide the face-up roller toward the gear end until the roller clears
the roller retainer (opposite the gear end), and lift it out of the
fuser assembly.
Figure 36. Remove the face-up rollers
Note When replacing the face-up roller bushing, verify that the locking pin is
seated correctly to prevent the roller from slipping out of the roller
retainer.
2
22
1
To Next Page
Loading...