Q1342-90910 Internal assemblies 55
Left plate assembly
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
z Front cover, toner cartridge door, and front guide. See “Front
cover” on page 32 through “Front guide” on page 36.
z Fuser assembly. See “Fuser assembly” on page 42.
2 Disconnect the laser/scanner ribbon cable (at the laser/scanner
end). Disconnect the laser/scanner wire harness and the ECU
ribbon cable from the connector PCB. Remove the laser/scanner
harness from the wire clip.
3 Remove the eight mounting screws (callout 1) and lift the left
plate assembly off of the printer.
Figure 44. Remove the left plate assembly
11
To Next Page
Loading...