60 Chapter 2 - Removal and replacement Q1342-90910
Paper-feed assembly
1 Remove the following assemblies:
z Toner cartridge, media tray and formatter pod. See “Toner
cartridge” on page 15 through “Cable pod” on page 17.
z Left side, back, and right side covers. See “Left side cover” on
page 18 through “Right side cover” on page 24.
z Right plate assembly. See “Right plate assembly” on page 48.
z ECU pan. See “ECU pan” on page 56.
Note Do not remove the gear shield instead of the right plate assembly. The
gear shield retains some of the gears. Removing the gear shield can
cause loose gears and springs to be misplaced.
2 Unwind the optic paper sensor and solenoid cables from the
cable guides (callout 1) on the paper-feed mechanism.
3 If necessary, remove one screw (callout 2) from the paper sensor
PCB assembly and remove the sensor PCB.
4 Remove the two mounting screws (callout 3) from the paper-feed
mechanism.
Figure 49. Remove wire harnesses
3
2
2
3
2
1
To Next Page
Loading...