Left-side cover
Removing the left-side cover is similar to removing the right-side cover. Use the steps and figures for
removing the right-side cover, except start the procedure by examining the tabs on the left side and
removing the screw on the left side.
NOTE If the cover cannot be removed easily, release one additional tab that is located on the
bottom of the printer near the center of the cover.
Rear panel and top-cover assembly
NOTE This procedure removes the rear panel and the top-cover assembly (the assembly
consists of the print-cartridge door and the fuser cover).
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 68.
● Left-side cover. See
Left-side cover on page 70.
2 Open the print-cartridge door.
3 Remove one screw (callout 1).
Figure 5-9 Remove the rear panel and top-cover assembly (1 of 6)
70 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...