HP LaserJet 1200 series - Using the Embedded Web Server

46 Chapter 3 Getting to know the print server
EN
To install the HP JetDirect
175X hardware
1 Use a network cable to connect the
175X to the network.
2 Use the USB cable to connect the
175X to your printer.
3 Attach the power module to the print
server.
4 Plug the module’s power cord into a
power receptacle.
5 The 10 and 100 LED should be
green, indicating that there is a
network connection. The
power/status LED should begin
blinking. Within 15 seconds the
power/status LED should be solid
green.
6 To print a configuration page and
verify the printer connection, press
the Test button.
7 Use the optional clip to physically
attach the print server to the back of
your printer or any convenient
location.
1
2
3
6
5
7