HP LaserJet 2100 - Page 252

240 Chapter 7 Removal and Replacement C4170-90959
Tray 1 Pickup Roller Removal
Be careful not to damage the paper sensor lever while removing the Tray 1 pickup roller.
The Tray 1 Pickup Roller Assembly is a field replaceable unit. See “Tray 1 Pickup Roller
Assembly Removal” (page 212) for more information.
1 Remove the following assemblies:
• Remove the toner cartridge. (See “Toner Cartridge Removal” (page 160) for
instructions.)
• Remove the DIMM cover. (See “DIMM Cover Removal” (page 175) for instructions.)
• Remove the rear cover. (See “Rear Cover Removal” (page 180) for instructions.)
• Remove the top cover. (See “Top Cover Removal” (page 192) for instructions.)
• Remove the left cover. (See “Left Cover Removal” (page 232) for instructions.)
• Remove Tray 1. (See “Tray 1 Removal” (page 237) for instructions.)
2 Rotate the left idler roller so that its release mechanism is accessible (see figure 7-115).
Figure 7-115 Release Mechanism on Idler Roller
3 Press and hold down the separation pad (see figure 7-116).
4 Press and hold the release button, and then slide the idler roller to the left (see figure
7-116).