246 Chapter 7 Removal and Replacement C4170-90959
1 Remove the following assemblies:
• Remove the toner cartridge. (See “Toner Cartridge Removal” (page 160) for
instructions.)
• Remove the DIMM cover. (See “DIMM Cover Removal” (page 175) for instructions.)
• Remove the rear cover. (See “Rear Cover Removal” (page 180) for instructions.)
• Remove the top cover. (See “Top Cover Removal” (page 192) for instructions.)
• Remove the left cover. (See “Left Cover Removal” (page 232) for instructions.)
• Remove the engine controller assembly. (See “Engine Controller Assembly Removal”
(page 189) for instructions.)
2 Remove the spring coil from the retaining clip located on the bottom of printer, and then
remove the spring arm from the retaining clip located on the bottom of printer.
Figure 7-123 Removing the Spring Coil and Arm from the Retaining Clips
3 Remove the spring arm from the retaining clip located on the side of printer (see figure
7-124). This releases the tension on the spring.
4 Squeeze the spring loop, and then slide it up and out of its slot.
To Next Page
Loading...