ENWW Loading trays 31
Loading trays
Loading tray 1 (multipurpose tray)
Tray 1 holds up to 100 sheets of paper or up to 10 envelopes. See the
following sections for printing on special media:
preprinted material—“Printing on letterhead, prepunched, or
preprinted paper (single-sided)” on page 42
envelopes—“Printing on envelopes” on page 37
labels—“Printing on labels” on page 39
To load tray 1
1 Open tray 1 by pulling the front cover down.
2 Slide out the plastic tray extender. If the media that is being loaded
is longer than 229 mm (9 inches), also flip open the additional tray
extender.
3 Slide the paper-width guides slightly wider than the media.
4 Place media into the tray (short-edge in, print-side up). The media
should be centered between the paper-width guides and under the
tabs on the paper-width guides.
5 Slide the paper-width guides inward until they lightly touch the
media stack on both sides without bending it. Make sure that the
media fits under the tabs on the paper-width guides.
Note
Do not add media to tray 1 while the printer is printing. This could cause
a paper jam. Do not close the front door when the printer is printing.
1
2
3
4
5
To Next Page
Loading...