Setting the fax-error-correction mode
Normally, the device monitors the signals on the telephone line while it is sending or
receiving a fax. If the device detects an error during the transmission and the error-
correction setting is On, the device can request that the portion of the fax be resent. The
factory-set default for error correction is On.
You should turn off error correction only if you are having trouble sending or receiving a fax,
and you are willing to accept the errors in the transmission. Turning off the setting might be
useful when you are trying to send a fax overseas, or receive one from overseas, or if you
are using a satellite telephone connection.
To change the error-correction setting
1. Press
MENU
/
ENTER
.
2. Use the < or the > button to select Fax setup, and then press
MENU
/
ENTER
.
3. Use the < or the > button to select All faxes, and then press
MENU
/
ENTER
.
4. Use the < or the > button to select Error correction, and then press
MENU
/
ENTER
.
5. Use the < or the > button to select On or Off, and then press
MENU
/
ENTER
to save your
selection.
ENWW Setting the fax-error-correction mode 65
English
To Next Page
Loading...
