HP LaserJet 3200 - Changing sound volume

EN Changing general default settings 39
Changing sound volume
You can control the volume of the following:
l The fax sounds associated with incoming and outgoing faxes.
l The ring for incoming faxes.
l The alarm sound the product emits when it requires attention,
such as when the printer door is open.
l The beeps emitted when you press control panel keys.
To change the fax sounds (line monitor) volume
Note The default set at the factory is Soft.
1 Press V
OLUME.
2 Use the < or > key to select
OFF, SOFT, MEDIUM, or LOUD, and
then press E
NTER/MENU to save your selection.
To change ring volume
The ring volume is heard when the device is initially sending or
receiving a call. The ring duration length is based on the local telecom
ring pattern length.
Note The default set at the factory for ring volume is Soft.
1 Press E
NTER/MENU.
2 Use the < or > key to select
COMMON SETTINGS, and then press
E
NTER/MENU.
3 Use the < or > key to select
VOLUME SETTINGS, and then press
E
NTER/MENU.
4 Press the > key once to select
RING VOLUME, and then press
E
NTER/MENU.
5 Use the < or > key to select
OFF, SOFT, MEDIUM, or LOUD, and
then press E
NTER/MENU to save your selection.