58 Chapter 2: Printing Tasks
EN
If the settings are not available from the software, set the custom
paper size from the control panel:
1 From the Printing Menu set
CONFIGURE CUSTOM PAPER=YES
.
2 From the Printing Menu, select inches or millimeters as the unit
of measurement.
3 From the Printing Menu, set the X dimension (the front edge of
the paper) as shown in Figure 16. X can be 3 to 8.5 inches (76 to
216 mm).
4 Set the Y dimension (the side edge of the paper) as shown in
Figure 16. Y can be 5 to 14 inches (127 to 356 mm).
5 If custom paper is loaded into Tray 1 and
TRAY 1
MODE=CASSETTE
, then set
TRAY 1 SIZE=CUSTOM
from the Paper
Handling Menu in the printer’s control panel. See “Customizing
Tray 1 Operation” on page 63.
If custom paper is loaded in the optional 500-sheet tray, be sure
the paper size dial is set to Custom (page 39).
6 In the software, select Custom as the paper size.
For example, if the custom paper is 8 by 10 inches (203 by 254 mm),
set X=8 inches and Y=10 inches (X=203 millimeters and Y=254
millimeters).
To Next Page
Loading...