146 Removing and replacing parts Q2431-90912
Top cover
Note If the optional stapler/stacker or stacker accessory is installed, lift it straight up and off of the printer
to remove it. Then proceed to step 2.
1. Remove the top accessory cover. See “Accessory covers and the tray 2 extension door” on
page 143.
2. Remove the two rear mounting screws (callout 1).
Figure 74. Top cover (1 of 5)
3. Open the print-cartridge door. Remove the front two mounting screws (callout 2).
Figure 75. Top cover (2 of 5)
21
22
To Next Page
Loading...
