Q2431-90912 Chapter 6 Removing and replacing parts 195
Paper feed assembly
1. Remove the following assemblies:
● Tray 1. See “Tray 1 ” on page 152.
● Tray 1 pickup assembly. See “Tray 1 paper-pickup assembly” on page 192.
2. Unplug the paper-feed assembly wire-harness connector from the DC controller PCA
(location J89; callout 1). Unweave the wire-harness from the wire guide (callout 2).
Hint It might be necessary to remove additional wire-harnesses from the wire guides to gain access
to the paper-feed assembly wire-harness.
Figure 151. Paper feed assembly (1 of 2)
2
11
2
To Next Page
Loading...
